Optional PowrCoat Multi-Gun Fluid Distribution Assemblies
Distribute Coating Safely Across Two, Three or Four Spray Guns
Shop verified PowrCoat 960 gun-manifold components for optional 1/4-inch and 3/8-inch multi-gun assemblies. Titan documents 2-gun, 3-gun and 4-gun configurations using nipples, ball valves, outlet fittings, pipe plugs and manifold block 970-100.
PowrCoat 960 Gun Manifold Assemblies Parts
This page is an exploded optional gun-manifold category. Titan identifies six complete configurations: 975-212, 975-213 and 975-214 for 1/4-inch outlets, plus 975-312, 975-313 and 975-314 for 3/8-inch outlets. The manifold block distributes pressurized coating while individual ball valves isolate gun outlets.
Functions Supported by the Assembly
- Distributes coating to multiple spray-gun circuits.
- Allows individual outlet isolation with ball valves.
- Supports 1/4-inch or 3/8-inch connection families.
- Seals unused ports with verified pipe plugs.
- Provides a central 970-100 distribution block.
When Repair Professionals Use This Page
- Building two-gun production setups.
- Servicing leaking outlet valves.
- Replacing damaged nipples or fittings.
- Correcting blocked or mismatched outlets.
- Maintaining optional multi-gun configurations.
Operating Symptoms and Diagnostic Priorities
Relieve all stored air and fluid pressure before service. Inspect the connected components and confirm the actual failure before replacement.
High-Value Replacement Parts
Only active products shown on the supplied page and retained after verification are linked below.
Titan 814-002 Nipple
Verified connection nipple used in manifold configurations.
Titan 940-553 Valve Ball
Fluid-control valve component used in the manifold assembly.
Titan 227-006 Outlet Fitting
Outlet fitting connecting the manifold to downstream fluid lines.
Titan 808-555 Fitting
Verified alternate fitting used in the manifold system.
Titan 227-033 Pipe Plug
Pipe plug sealing unused manifold ports.
Titan 970-100 Manifold Block
Central 3/8-inch manifold block for fluid distribution.
How to Select the Correct Replacement
Confirm the machine and assembly
Match PowrCoat 960 and the exact assembly page.
Match the diagram callout
Use the verified part number and component name.
Diagnose connected parts
Inspect seals, threads, valves and mating surfaces.
Order only confirmed products
Avoid discontinued, mismatched or unverified listings.
Maintenance Priorities
- Relieve pressure before servicing any outlet.
- Flush all manifold passages after use.
- Exercise ball valves to prevent coating buildup.
- Inspect plugs and fittings for thread damage.
- Support hoses to reduce side load.
- Verify every outlet is rated for system pressure.
Plan a Complete Repair
Record the PowrCoat 960 model, diagram position, symptom and exact leak, restriction or wear location before disassembly. Photograph hose routing and component orientation where useful.
Inspect each mating pair during teardown and replace only after confirming the true failure point. This approach reduces unnecessary parts cost, repeat downtime and installation errors.
Shop Major Components
PowrCoat 960 Gun Manifold Assemblies Parts FAQs
Contractor-focused answers based on the supplied category and verified Titan documentation.
Repair the PowrCoat 960 With Verified Components
Use the exact part number, assembly callout and operating symptom to narrow the correct replacement.
- Titan part number
- Assembly diagram callout
- PowrCoat 960 model
- Component or service-kit name
- Leakage, restriction or operating symptom