Commander Gun Manifold Assemblies Parts

Verified SPEEFLO Commander Parts Diagram

Commander Gun Manifold Assemblies Parts

Titan documents six Commander gun-manifold assemblies: 975-102, 975-104 and 975-111 for 1/4-inch systems, plus 975-302, 975-304 and 975-311 for 3/8-inch systems. Configurations provide two-gun, four-gun and one-gun add-on arrangements.

Built for contractors, repair shops, maintenance technicians and buyers who need verified Commander component identification and diagnosis-first repair guidance.

Verified Diagram Scope

Part numbers and names are restricted to the current category and Titan Commander documentation.

Diagnosis Before Replacement

Every recommendation begins with inspection of genuine assembly components.

Six-Card Maximum

The commercial section contains no more than six verified component cards.

Verified Commander Links

Navigation uses confirmed machine-family and assembly-category destinations only.

Assembly Overview

Verified component index: 975-102, 975-104, 975-111, 975-302, 975-304, 975-311

Functions Supported by the Assembly

Primary Assembly Function

Two-gun manifold, 1/4 inch performs a central function within this documented Commander system.

Pressure or Flow Support

Four-gun manifold, 1/4 inch supports controlled pneumatic, fluid or structural operation.

Sealing and Retention

One-gun add-on, 1/4 inch contributes to sealing, alignment, filtration, retention or stability.

Service Identification

The exploded page separates genuine service components from adjacent Commander systems.

Service Applications

Use this page for model identification, preventive inspection, targeted repair, assembly rebuilding, pressure or flow diagnosis and purchasing for Commander equipment that specifically uses this assembly.

Troubleshooting

Operating symptom	Inspect first	Diagnosis before replacement
Loss of pressure or output	manifold 970-100	Relieve pressure and inspect manifold 970-100 for wear, leakage, blockage, contamination, looseness or incorrect installation. Confirm the actual fault and inspect connected systems before replacement.
Irregular cycling or pulsation	ball valves 940-553 or 941-555	Relieve pressure and inspect ball valves 940-553 or 941-555 for wear, leakage, blockage, contamination, looseness or incorrect installation. Confirm the actual fault and inspect connected systems before replacement.
Visible fluid or air leakage	hex nipples	Relieve pressure and inspect hex nipples for wear, leakage, blockage, contamination, looseness or incorrect installation. Confirm the actual fault and inspect connected systems before replacement.
Restricted flow or movement	pipe plugs	Relieve pressure and inspect pipe plugs for wear, leakage, blockage, contamination, looseness or incorrect installation. Confirm the actual fault and inspect connected systems before replacement.
Startup or priming failure	correct 1/4- or 3/8-inch configuration	Relieve pressure and inspect correct 1/4- or 3/8-inch configuration for wear, leakage, blockage, contamination, looseness or incorrect installation. Confirm the actual fault and inspect connected systems before replacement.
Recurring fault after service	pressure rating of connected equipment	Relieve pressure and inspect pressure rating of connected equipment for wear, leakage, blockage, contamination, looseness or incorrect installation. Confirm the actual fault and inspect connected systems before replacement.