Titan 540ix Siphon/Return Assembly Parts
Find genuine Titan replacement components for the 540ix siphon/return assembly identified as P/N 704-300. Shop the intake hose, return hose, inlet screen and connection hardware by matching the factory diagram to your sprayer.
Shop Titan 540ix Intake and Return Components
Identify the component requiring attention before ordering. Compare the hose package contents with the individual fittings and seals already installed on your machine.
Replaces 700-1023 and 700-659. The listed package includes the siphon hose, O-ring, elbow and retaining clip. Check these contents before adding separate connection parts.
View Siphon Hose →The return hose carries material back during priming. The current listing replaces 704-263 and 0508605. Confirm your existing hose number and routing before purchasing.
View Return Hose →The inlet screen helps keep debris out of the intake path. Inspect it for accumulated coating and physical damage, then confirm the specified replacement against your diagram.
View Inlet Screen →How to Choose the Correct Siphon/Return Part
Use the model identification and numbered assembly drawing together. Similar hose connections do not establish compatibility, and an assembly reference does not identify every individual service part.
Check the model label and record the serial number for fitment assistance.
Match the installed part to its position in the assembly drawing.
Compare the original number with any documented replacement number.
Check included seals and fittings so your order covers the required repair.
| Diagram Position | Titan Part Number | Component | Ordering Check |
|---|---|---|---|
| 1 | 700-1023A | Siphon hose | Review included connection parts |
| 2 | 704-263A | Return hose assembly | Confirm replacement number |
| 3 | 700-805 | Inlet screen filter | Match the intake screen |
| 4 | 9871105 | O-ring | Replaces 704-121 |
| 4A | 704-109 | O-ring | Check the specified seal position |
| 5 | 700-1024 | Elbow | Check fitting condition |
| 6 | 9822526 | Retaining clip | Match the connection hardware |
| Not shown in listed callouts | 0279459 | Clip | Confirm location before ordering |
Important: Match each O-ring to its specified position. Do not select a seal by appearance or assume the two listed O-rings are interchangeable.
Inspect the Assembly Before Replacing Parts
Begin with the location of the problem rather than replacing the entire intake system. Priming or flow problems require diagnosis; a symptom alone does not identify a failed hose or seal.
Confirm sufficient coating is available and follow the manual's setup instructions.
Look for visible damage, sharp bends and coating buildup. Replace damaged components as instructed.
Identify the exact source of leakage and check that the specified seals and retaining hardware are present.
If symptoms remain, follow the troubleshooting procedure before ordering additional components.
Service safety: Follow the sprayer manual's pressure-relief procedure, disconnect power and observe its cleaning and servicing instructions before removing components.
For components outside this assembly, visit Titan 540ix Main Assembly Parts.
Titan 540ix Siphon/Return Assembly FAQ
Use these ordering checks alongside the factory diagram and your equipment information.
Have your model, serial number, diagram position and existing part number ready for help selecting the correct replacement.
Call 713-931-0006 for Fitment Help






