GENUINE TITAN OEM • DRIVE AND CONTROL SERVICE PARTS
Titan 330 Gear Box Assembly Parts
Shop genuine Titan 330 Gear Box Assembly Parts using the exploded diagram and OEM references. Identify thrust washers, the front cover, transducer, switches and related service hardware by callout, then choose the correct component for your machine and repair.
Identify the Component Before Planning the Repair
The assembly breakdown provides a direct reference between the component’s position and its ordering number. Start with the area being serviced, locate its numbered callout and match it to the Titan OEM reference.
Choose replacement parts after inspecting the machine. A symptom helps direct diagnosis, while the diagram helps identify the component that the diagnosis shows needs attention.
Order the Correct Part in Three Steps
01 • CONFIRM THE MODEL
Check the Titan 330 machine identification and relevant motor or control configuration.
02 • FIND THE CALLOUT
Locate the component on the exploded drawing and record its reference.
03 • MATCH THE OEM NUMBER
Verify the part number, package contents and required quantity before checkout.
Titan 330 Gear Box Component Reference
Use each callout as a location reference. Confirm supplied quantities separately and verify any replacement number before ordering.
Understand the Different Service Areas
Thrust washer 700-680 provides a bearing surface for axial loads between adjoining components. Inspect the washer and mating surfaces together when assessing wear.
The 704-119 transducer kit belongs to the pressure-sensing service area. Its appearance in this breakdown does not make it a replacement for a mechanical drive component.
Keep mechanical wear, electrical faults and fluid-system problems separate during diagnosis. Select the part associated with the confirmed fault and follow the relevant installation procedure.
Inspect Before Replacing Drive or Control Components
Unusual noise, intermittent operation or pressure changes can have more than one cause. Inspect the relevant system using the service instructions for your machine instead of replacing a component solely because its name appears related to the symptom.
During disassembly, retain component orientation and location information. Check adjoining contact surfaces and mounting areas before fitting new parts. Use the specified assembly and lubrication procedures rather than assuming a general gear box maintenance method applies.
Before servicing: Follow the manufacturer’s pressure-relief procedure and disconnect electrical power. Have electrical and internal drive repairs performed by a qualified technician. Never bypass protective components.
Continue to the Correct Titan 330 Parts Section
For repairs outside this assembly, use the relevant breakdown to identify the component in its proper system.
Choose Titan 330 OEM Parts with Confidence
Match the diagram reference, machine configuration and OEM number before ordering. If you need identification assistance, have the existing part number, serial details where available and clear component photographs ready.
Call 713-931-0006 for Parts HelpTitan 330 Gear Box Assembly Parts FAQ
Answers about component identification and repair selection.
Which machine does this diagram cover?
This section covers the Titan 330 gear box assembly breakdown. Confirm your machine identification and configuration before ordering.
How do I select the correct thrust washer?
Use the exact diagram position and OEM number. The washers at callouts 4, 16 and 18 have separate part numbers and should not be selected by appearance alone.
Does a pressure problem mean the transducer has failed?
No. Pressure symptoms can involve several systems. Diagnose the machine before deciding whether a sensing, control or fluid component needs replacement.
Can I purchase individual service components?
Use the component listings to order the identified service part. Review supplied contents and the condition of adjoining components before planning the repair.
Can I use parts from another Titan sprayer?
Use another model’s component only when its OEM number and application confirm compatibility. Similar model names or dimensions do not establish fitment.