Titan part 441-968 is a stirrup, 3/4" used in the fluid section or mechanical linkage of compatible Commander and Hydra airless sprayers. This stirrup (also called a yoke or clevis) provides a pivoting connection between the connecting rod and the pump piston or crosshead. A worn, cracked, or bent stirrup can cause misalignment, binding, or failure of the pump drive. Replacing with the OEM stirrup restores proper mechanical linkage and smooth pump operation.
| Part Number | 441-968 |
|---|---|
| Part Description | Stirrup, 3/4" |
| Brand | Titan |
| Fits |
|
| Condition | New |
The Titan 441-968 Stirrup, 3/4" is a genuine OEM replacement yoke (clevis) used in the pump drive linkage of Commander and Hydra series airless sprayers. It connects the connecting rod to the pump piston crosshead, allowing pivotal movement while transmitting reciprocating force.
Over time, stirrups can wear at the pin holes, crack from fatigue, or become bent under overload. A damaged stirrup causes slop in the linkage, erratic pump motion, unusual knocking sounds, or complete drive failure. Replacing with OEM Titan 441-968 restores proper alignment, smooth reciprocation, and reliable pressure output.
| Connects rod to piston | Transfers force from connecting rod to crosshead |
|---|---|
| Allows pivoting | Provides hinge point for reciprocating motion |
| Maintains alignment | Keeps piston centered in cylinder bore |
| Load bearing | Withstands alternating tension and compression |
| Elongated pin holes | Excessive play at pivot points |
|---|---|
| Visible cracks | Stress fractures in the stirrup body |
| Bent or twisted | Stirrup no longer straight, causing binding |
| Worn or seized pivot | Stirrup does not move freely on pins |
Titan part 441-968 is a direct OEM replacement stirrup for the following models. Always verify with your machine's parts diagram.
| Model | Component |
|---|---|
| Commander (741-440) | Stirrup, 3/4" |
| Commander (761-301) | Stirrup, 3/4" |
| Commander (761-411) | Stirrup, 3/4" |
| Commander (741-331) | Stirrup, 3/4" |
| Hydra M | Stirrup, 3/4" |
| Hydra Pro Super | Stirrup, 3/4" |
When replacing the stirrup, inspect these associated components.
Inspect rod end for wear or bending.
Replace worn pins and bushings to eliminate play.
Check for damage or scoring on mating surfaces.
Copyright © 2024 AlltitanParts.com - All Rights Reserved.
