Titan part 9971182 is an O-ring used to create a leak-proof seal between components on compatible SprayTech AirCoat GM 2600 and Stati Kit 2000 systems. When the original O-ring becomes worn, compressed, or damaged, it can cause fluid or air leaks, leading to pressure loss and inconsistent performance. This O-ring restores proper sealing and reliable operation.
O-Ring for SprayTech AirCoat GM 2600 and Stati Kit 2000
The Titan part 9971182 O-Ring is a precision elastomeric sealing component designed for use in SprayTech AirCoat GM 2600 and Stati Kit 2000 systems. This O-ring creates a reliable, leak-proof seal between mating components, preventing fluid or air escape and maintaining system pressure for optimal performance.
A worn or damaged O-ring is a common cause of leaks, pressure drops, and inconsistent spray performance. Replacing with this genuine component ensures proper sealing, prevents material waste, and maintains the integrity of your SprayTech finishing system.
Installation Note: Lightly lubricate the O-ring with compatible grease before installation to prevent pinching and ensure proper seating in the gland. Avoid over-stretching during installation.
What it does and when to replace it
What the O-ring does
Fluid sealing
Prevents material leakage at component joints
Air sealing
Maintains pneumatic pressure in air systems
Contamination prevention
Keeps contaminants out of sealed areas
Pressure maintenance
Helps sustain system operating pressure
When replacement is recommended
Visible leakage
Fluid or air escaping at sealed joint
Hardening or cracking
O-ring material deteriorated with age
Flattening or deformation
O-ring no longer maintains round cross-section
During disassembly
Always replace O-rings when components are apart
Compatibility
The 9971182 O-ring is designed for use in the following SprayTech systems. Always verify your specific application before ordering.
System
Application
SprayTech AirCoat GM 2600
O-ring replacement
SprayTech Stati Kit 2000
O-ring replacement
Related parts commonly serviced together
When replacing O-rings, these related sealing components are often inspected or replaced to ensure complete system reliability.
Back-up rings
Used with O-rings in high-pressure applications to prevent extrusion.
Seal kits
Complete sets of seals for major service work.
Lubricant
Compatible grease or oil for O-ring installation.
Frequently Asked Questions
The 9971182 O-ring is manufactured from a material specifically selected for compatibility with the fluids and operating conditions of SprayTech AirCoat and Stati Kit systems. It is typically made from a durable elastomer such as Buna-N (Nitrile), Viton (FKM), or another compound that resists degradation from paints, solvents, and coatings while maintaining flexibility over a wide temperature range.
Signs that your O-ring needs replacement include: visible fluid or air leakage at the sealed joint, hardening or cracking of the O-ring material, flattening or permanent deformation (loss of round cross-section), or if the O-ring was removed during disassembly. As a general rule, O-rings should be replaced whenever components are disassembled for service, as they are inexpensive compared to the cost of rework from leaks.
Yes, the 9971182 O-ring is designed to work in both SprayTech AirCoat GM 2600 and Stati Kit 2000 systems. These systems share common sealing requirements and component configurations where this specific O-ring size and material are used. Always verify the location and application to ensure correct fit.
Proper installation includes: 1) Ensure the O-ring groove and mating surfaces are clean and free of debris, 2) Lightly lubricate the O-ring with a compatible grease (check your system's requirements), 3) Carefully place the O-ring in the groove without twisting or stretching excessively, 4) Assemble components slowly, ensuring the O-ring remains in place and is not pinched, and 5) Tighten to specification. Never use sharp tools that could nick the O-ring during installation.
