Part 0533280 is a specific O-ring used as a sealing component within an HVLP spray system. It prevents air or fluid leaks at connection points, ensuring system integrity and consistent performance. This O-ring is a critical small part for maintaining a leak-free assembly.
| Part Number | 0533280 |
|---|---|
| Part Description | O-Ring |
| Fits | HVLP Airspray Profinish TS40; TS 50 |
| Condition | New |
The 0533280 is a precision O-ring designed to fit a specific location within the HVLP spray gun or its associated components. It creates a static seal between two mating surfaces, preventing air leaks that would disrupt spray performance or fluid leaks that could cause messes and pressure loss.
A worn, nicked, or hardened O-ring will fail to seal properly, leading to audible air leaks, loss of pressure, fluid seepage, or inconsistent spray patterns. Replacing this small but vital component is often the solution to restoring a tight, leak-free connection.
| Sealing Function | Compresses between parts to create an airtight or fluid-tight barrier |
|---|---|
| Pressure Integrity | Maintains system pressure by preventing leaks at threaded or push-to-connect fittings |
| Component Interface | Allows for secure yet separable connections between different parts of the system |
| Visible Leaks | Audible air hissing or visible fluid seepage from a connection point |
|---|---|
| Physical Damage | Nicks, cuts, tears, or flat spots on the O-ring that compromise its round cross-section |
| Loss of Elasticity | O-ring feels hard, brittle, or does not spring back to shape when deformed |
| Preventive Maintenance | Replacement during routine cleaning or whenever the assembly is taken apart |
Part 0533280 is specified for use in the listed HVLP spray systems. Its precise inner diameter, cross-section, and material are matched to the specific groove dimensions and chemical exposure of its application.
| Spray System Model | Component |
|---|---|
| HVLP Airspray Profinish TS40 | O-Ring |
| HVLP Airspray Profinish TS 50 | O-Ring |
O-rings are often part of a sealing system. When one fails, others in the same assembly or of similar age and material may also be near the end of their service life.
Other flat or molded seals in the same component may also need replacement.
The fittings that the O-ring seals between should be inspected for damage or cross-threading.
Appropriate O-ring lubricant (like silicone grease) is often used during installation to prevent pinching and aid sealing.
Copyright © 2024 AlltitanParts.com - All Rights Reserved.
